Paccar Kenworth T800 2012, Manual

Page: 245 / 276

8-25
08/12
Section 8
Electrical
ADDITIONAL SPARE CIRCUITS
If you just need spare power wire into one of 18 spare circuits we provide.
Do not install an electrical circuit that requires more amperage (electrical capacity) than
what is available in the specific chassis circuit. An overloaded circuit could cause a fire.
Compare the amperage requirements of the new circuit to the electrical current capacity of
the existing chassis circuit before adding the body or other equipment.
The central electrical panel (CEP) has a total of 18 spare circuits (2 of which can be connected to spare relays on the
CEP).
They include:
• 8 spare battery circuits
• 2 spare low voltage disconnect circuits
• 4 spare accessory circuits
• 4 spare ignition circuits
Some spare circuits may be used with factory installed options. For specific chassis questions
please work with your Kenworth Dealer.
Spare Circuit Bullet Connectors
1. Remove the LH gauge panel above ignition key switch.
2. From behind the gauge panel, locate one of the 18 spare BATT, LVD, ACC, or IGN bullet connectors not currently be-
ing used. See Figure 8-18.
FIGURE 8-18.
Spare Bullet Connectors
WARNING!
Note: