31
Measure the distance from the motor mounting surface to
the inner brake race. With all components properly installed,
this distance should be 11/16 in. (17.5 mm) to 3/4 in. (19.1
mm). If this distance is less than 9/16 in. (14.3 mm), the pri-
mary spacer may be positioned as shown below and should
be checked.
Th
e Primary
Th
rust Plate is shown wedged between the plan-
et gears and the planet carrier. Note that the Primary Sun
Gear and the entire Brake Clutch Assembly have moved to
the right (toward the hydraulic motor).
16. Engage the motor sha
ft
with the brake clutch inner race
and lower motor into place. Tighten capscrews to
recommended torque.
17. Install the hoses that connect the manifold and brake
valve to the brake cylinder.
18. A
ft
er the hoist assembly is complete, check all capscrews
and
fi
ttings to make certain they have been tightened cor-
rectly.
Re
fi
ll the hoist with the recommended oil listed under “Pre-
ventive Maintenance”, and install the oil level plug.
