21
2. Insert two (2) bearings and a bearing spacer into a gear
with the spacer between the bearings. Place a thrust
washer on each side of the gear and position in a car-
rier opening. Slide the sha
ft
through the carrier, thrust
washer, bearing-gear sub-assembly and remaining thrust
washer. Be careful to avoid damaging thrust washers
when installing planet sha
ft
s.
3. Carefully align the pin hole in the carrier with the hole
in the planet gear sha
ft
and drive the roll pin into place.
Always use NEW roll pins.
4. Note that the roll pin is recessed approximately 1/16 in.
(.06 mm) in the carrier when properly installed. With
a center punch, stake the carrier next to the pin hole as
shown.
Th
is will distort the hole so the pin will not back
out. Repeat these steps for each of the three planet gears.
PRIMARY PLANET CARRIER
1. To service the primary planet carrier, the steps are the
same as for the output carrier except there is only one
bearing for each gear and no bearing spacer.
