31
Measure the distance from the motor mounting surface to the
inner brake race. With all components properly installed, this
distance should be 11/16 to 3/4 inch (17.5 to 19.1 mm). If this
distance is less than 9/16 inch (14.3 mm), the primary spacer
may be positioned as shown below and should be checked.
The Primary Thrust Plate is shown wedged between the
planet gears and the planet carrier. Note that the Primary Sun
Gear and the entire Brake Clutch Assembly have moved to
the right (toward the hydraulic motor).
22. Engage the motor shaft with the brake clutch inner race
and lower motor into place. Tighten capscrews to
recommended
torque.
23. Install the hoses that connect the manifold and brake
valve to the brake cylinder.
24. After the hoist assembly is complete, check all capscrews
and fittings to make certain they have been tightened cor-
rectly.
25. Refill the hoist with the recommended oil listed in the
“Preventive Maintenance” section of this manual and
install the oil level plug.
