21
2. Insert two bearings and a bearing spacer into a gear with
the spacer between the bearings. Place a thrust washer on
each side of the gear and position in a carrier opening.
Slide the shaft through the carrier, thrust washer, bear-
ing-gear sub-assembly and remaining thrust washer. Be
careful to avoid damaging thrust washers when installing
planet shafts.
3. Carefully align the pin hole in the carrier with the hole
in the planet gear shaft and drive the roll pin into place.
Always use NEW roll pins.
4. Note that the roll pin is recessed approximately 1/16 inch
(.06 mm) in the carrier when properly installed. With
a center punch, stake the carrier next to the pin hole as
shown. This will distort the hole so the pin will not back
out. Repeat these steps for each of the three planet gears.
PRIMARY PLANET CARRIER
1. To service the primary planet carrier, the steps are the
same as for the output carrier, except that there is only
one bearing for each gear and no bearing spacer.
