PAC MMC200, Operating Manual

Page: 12 / 16

Model MMC200 Multi-Material Cutter
lower it down again to ensure the upper blade does
not come down on top of the lower blade.
5. Lower the upper blade all the way down and
tighten the left tension screw on the lower blade
holder until the lower blade is snug against the
upper blade.
6. Raise the upper blade and slowly lower it back
down. There should be a smooth shearing action
like a pair of scissors. If not, repeat steps 3 thru 5
again until you achieve a smooth shearing action.
7. Tip the machine onto its backside and tighten
the two screws securing the lower blade holder
with the 3/16" Allen wrench.
8. Return the machine to an upright position and
recheck the shearing action of the blades.
9. Return the machine to service by installing the
safety guard, air supply and power.
TROUBLESHOOTING
Problem Possible Cause Possible solution
Material does not Feed Feed System not closed Close Feed System with Engage Belt Feed Switch
Inadequate Air Supply Check Air Supply per set up
Guard Open Install Guard
Out of Material Load Material
Display not Functioning Blown Fuse Replace with recommended Fuse
No Cut Inadequate Air Supply Check Air Supply per set up
Material over specification Check maximum size per specification
Blades out of Adjustment See Blade adjustment procedure
Dull Blades Replace with recommended Blades
Poor Cut Dull or Chipped Blades Replace with recommended Blades
Blades out of Adjustment See Blade adjustment procedure
Erratic Cut Lengths Uneven Dereeler Tension Adjust Tension on Dereeler or use a Power
Assisted Dereeler for high speeds
Production Automation • Eden Prairie, MN USA • Ph: 888-903-0333 • info@gotopac.com • www.gotopac.com • Fax 952-903-0315