23
4.1
Installing software for the installer
In the case the string of modules is different from 12 modules or the batteries are not standard it is
necessary to configure Solar Eclipse using the installer software. In any case, for a professional installation
of the equipment and for maximum performance and reliability of the system it is recommended to always
use the configuration via PC.
On
www.solareclipse.it/en/download
you can download the software and system libraries needed to run
the Solar Eclipse configurator, the use is reserved to authorized installers only. To install the software,
proceed as follows:
•
Goto www.solareclipse.it/en/download
•
Download the zip file
“
Solar Eclipse
Configurator”
•
Unzip it and save all files in a folder in your PC
•
Run the exe file you will find in the folder
If the above operations have been
carried out correctly the software will
start and you will see the screen in Fig
12:
Connect the USB / RS485 interface cable to the PC and to Solar Eclipse (see Figure 7) ensuring that the Solar
Eclipse is in lock state (LED indicator on the left flashes).Select the COM port using the dropdown at the
bottom left used by your PC and initiate communication with the key "start." In the bottom bar will show
the message in green "COMMUNICATION OK". The software Solar Eclipse Configurator is now successfully
installed and ready to set the operating parameters of Solar Eclipse, and verify the optimal functioning of
the system.
NOTE:
In order to use the USB / RS485 interface installer provided by P800 SRL, you must
first install the drivers included in the package.
NOTE:
For proper operation, use only the original P800 SRL cable.
Figure 12 - Configuration Software
–
Trend tab
