P3 International GSE3226STG, General Instruction Manual

Page: 7 / 64

7
ENGLISH
ASSEMBLY INSTRUCTIONS
ASSEMBLE THE DISCHARGE CHUTE
1. Loosen and remove the butterfly bolt and flat washer from the chute chassis.
2. Put the discharge chute into the chute chassis as shown (Fig.4)
Fig.4
3. Align the hole of the discharge chute with the hole of Chute chassis, fasten the butterfly bolt and flat washer
previously removed (Fig5).
ATTACHING CHUTE DIRECTIONAL CONTROL
1. Remove the hairpin clip from the upper chute rod. Slide the upper chute rod through the upper chute rod
bracket and into the lower chute rod. A pair of pliers may help in this job. See Fig.3.
2. Align the two holes on both chute rods and insert the hairpin clip removed earlier, through these holes. See
Figure 3.
Discharge chute
Chute chassis
Fig.5