Page
3
of
13
Copyright © 2015 P2 Mobile Technologies Limited. All rights reserved.
WIRELESS ACCESS POINT USER MANUAL
Safety Instructions
1.
Read these safety instructions carefully before installation or usage.
2.
Keep this user manual for later reference.
3.
Disconnect the access point from the power source before cleaning. Use a damp cloth for
cleaning. Do not use liquid or spray detergents.
4.
To avoid risk of injury from electrical shock or energy hazard, installation and service of this
product must be performed by qualified service personnel.
5.
Install the access point on a reliable surface. Poor installation may cause it to fall onto people or
equipment and make body injury and equipment damage.
6.
Do not install the access point near the power line, electric lamp, power grid, or in any forceful
power grid place.
7.
To acquire steady power, connect the PoE port with a network cable under 50m. The network
cable compiles with the DC resistance definition in the YD/926.2 protocol.
8.
Make sure the voltage of the power source is correct before connecting the access point to the
power outlet.
9.
Use a steady power source to ensure normal functioning.
10.
Ensure the power adapter is grounded well when installing the access point indoor.
11.
The lightning protection module inside the device is basic. Install any additional protection if
necessary.
12.
Position the power cord so that people cannot step on it. Do not place anything over the power
cord.
13.
All cautions and warnings on the device should be noted.
14.
If the access point is not used for a long time, disconnect it from the power source to avoid
damage by transient overvoltage.
15.
Never open the access point. For safety reasons, the access point should be opened only by
qualified service personnel.
16.
If one of the following situations arises, get the equipment checked by service personnel:
i.
The power cord or plug is damaged.
ii.
Liquid has penetrated into the access point.
iii.
The access point does not work well, or you cannot get it to work according to the user's
manual.
iv.
The access point has been dropped and damaged.
v.
The access point has obvious signs of breakage.
17.
DO NOT LEAVE THE ACCESS POINT IN AN ENVIRONMENT WHERE THE STORAGE TEMPERATURE
MAY GO BELOW 0° C OR ABOVE 45° C. THIS COULD DAMAGE THE ACCESS POINT.
