3.
STARTING PROCEDURE
Before starting make sure machine is clear of materials
and all non-essential persons.
The machine is shipped
without
fuel/2 stroke oil mixture, therefore you MUST fill the engine with fuel/2 stroke
oil before starting the engine. Failure to do so will result in engine damage which will not be covered by
warranty.
3.1.
Starting procedure. – from cold i.e. machine has not been run for some time.
Put the power switch to ON position. Move the choke lever to
START
position. Press the primer bulb
7/8 times. Holding the machine firmly pull the recoil starter handle until machine starts. When machine
starts adjust the choke lever to the
RUN
position until machine runs smoothly. Allow the engine to
warm up for a few minutes.
3.1.1. Starting procedure. – from warm i.e. machine has been run recently.
Put the switch to ON position. Make sure the choke lever is in the
RUN
position. Holding the machine
firmly pull the recoil starter handle until machine starts. Allow the engine to warm up for a few minutes.
Page 9
Summary of Contents for P5200EA
Page 2: ...Page 2...
Page 21: ...9 PART LOCATIONS Page 21...
