4.
STOPPING PROCEDURE
4.1.
Before stopping the machine allow the engine to cool down for a few minutes, by
allowing it to run without throttle.
4.2.
You MUST allow the auger drill bit to come to a full stop before carrying out any
maintenance on the machine.
4.3.
To stop the machine.
Allow the machine to cool down with no throttle applied. Turn the power switch OFF. If not already in
RUN
position move the choke to the
RU
N position.
Page 10
Summary of Contents for P5200EA
Page 2: ...Page 2...
Page 21: ...9 PART LOCATIONS Page 21...
