P1PE P5200EA, User Manual

Page: 14 / 24

6. MAINTENANCE
Always stop the engine and unplug the spark plug before doing any repairs or maintenance.
Never touch the rotating nylon cord or blade.
Check and maintain fuel level regularly, and maintain the fuel/oil mix to the correct ratio.
Frequently check the auger and make sure that all deposits are removed from the auger drill
bit.
At regular intervals, check the tightness of all nuts, bolts and screws.
If the auger drill bit hits an obstacle check for damage. If the machine vibrates badly stop the
machine and take it to a service dealer.
Always refuel in a well-ventilated area with the engine off and spark plug HT cap removed.
Whilst carrying out maintenance you must wear appropriate Personal Protective Equipment
(PPE). Suggested PPE Sturdy footwear, work gloves, long trousers and hearing protection.
NEVER use a “pressure washer” to clean your auger. Water can penetrate the power unit and
cause damage the engine. The use of pressure washers will result in shortened life and
reduce serviceability. Shut down the engine, wait for all moving parts to come to a complete
stop, remove HT lead, and then wait for 5 minutes before performing maintenance on the
chipper.
ITEM
Every
use
Every 3
months
or 15
hours
Every 6
months
or 50
hours
Every 12
months
or 100
hours
Every 24
months
or 300
hours
Air filter
Check #
Clean # a
Fuel filter
Check #
Clean
#
Replace
as
required
Spark plug
Check/Adjust #
Change #
Gear box Check/fill
Recommended change interval. 1st check after 30 hours
of use. Thereafter every 25 hours of use.
Cooling fins Check clean #
Mechanical
connections Check/Tighten/Examine
#
Fuel tank Examine #
Fuel pipes Examine Each time replace as required.
a = Increase maintenance interval if operating in dusty environment.
Page 14