P+S Technik Weisscam HS-1, Operator'S Manual

Page: 41 / 66

PREVIEW and SAVING >> G|1
OPERATOR‘S GUIDE BOOK
PREVIEW AND SAVING
Preview
->
Check the whole image carefully. Is the image in focus?
Do you see burning areas or hot spots, do you see a horizontal
stripes caused by a very hard light. Is the gamma correct, is the
saturation not too high and not to low etc.
This check is very important, you have to check it all
the time!
1. Press the green PLAY button
(make sure, you do not
press the red Record button….)
2. Change Preview Speed by moving the marker of the Speed Bar
to the right (faster) or to the left (slower).
Set the speed to approximately 25 fps for normal review.
->
If there is no speed bar, please check under
File > Options >
Toolbar
if
Show Speed Bar
is active !
3. Use fast forward and fast backward
to reach the desired part of the recorded sequence.
4. Playback speed at 25 fps allows you to carry out a visual check. To
control recorded frame rate.
5. Write down the Cut in and the Cut out points of the sequence. Give
a few more frames at the beginning and at the end.