P+S Technik Weisscam HS-1, Operator'S Manual

Page: 19 / 66

PREPARATION >> D|3
OPERATOR‘S GUIDE BOOK
Camera
Put the appropriate lens mount on the camera (PL-Mount, Nikon F-Mount etc.)
Provide the appropriate adaptor plate for the tripod
Put a battery onto the camera not to loose data in case someone unplugs the camera.
Plug in and turn on CAMERA
Wait till you see two green lights (power and camera) lit at the back of the camera. The camera is
now ready to shoot. If you get a different blinking signal, please refer to the following interpretation
of the flash code of the two LEDs on the camera:
Camera LED:
_ Flashing orange/off >> camera not ready (appears on camera start up)
_ Steady green >> camera ready
_ Steady orange >> recording/live previewing
Power LED:
_ Flashing orange/off >> power supply not ready (appears on camera start up)
_ Flashing red/orange >> impressed voltage too high (above 16 volts)! RISK OF DAMAGE.
Please change power supply!
_ Flashing green/orange >> impressed voltage slightly too high (between 15 and 16 volts).
No problem for shot time. Appears mostly for about 5 minutes, when
a completely charged battery is attached to the camera.
_ Steady green >> impressed voltage within the operating range
(between 10.8 and 15 volts); power supply ready
_ Flashing orange/off >> impressed voltage low (between 10,8 and 10,4 volts).
When you are using batteries, please change it now!
_ Flashing red/off >> impressed voltage very low (below 10,4 volts).
Camera is in sleeping mode in order to prevent damage.
The ventilator keeps on running to cool down the camera.
RISK of damage of IDE batteries!
IMPORTANT:
To reactivate the camera please change the battery and switch the camera OFF and ON again. All
data of the cameras memory is erased!
Load “calibration charts” from NVIDIA graphic card “tools” and calibrate viewfinder and all con-
nected monitors.
1.
2.
3.
4.
5.
6.