P+S Technik Weisscam HS-1, Operator'S Manual

Page: 39 / 66

RECORDING >> F|1
OPERATOR‘S GUIDE BOOK
RECORDING
Software Triggering
1. Check your image size, frame rate and trigger details in Window
Camera Control
by clicking three times in the status line of the
Camera Control
Window.
2. Choose Trigger Mode
Auto Sequence
or
Soft Trigger
.
3. Choose Recording Mode
Sequence
or
Ring Buffer
.
4. Press the red Record Button. The lever turns and the CamRam
Level Indicator is filling up.
->
In Recording Mode
Ring Buffer
the CamRam Level Indica-
tor will fill up once and stay full till stop signal. If you stop too early,
you do not have recorded the full 4 GB RAM ! Always wait until the
indicator is full.
5. Press the STOP button . The sequence is now recorded and
stored in the RAM of the camera. The total amount of recorded
images is showed in the status line. Make sure, it is never over
10.000 frames, because you cannot save more than 9.999 frames!
For previewing and saving, please go to Chapter:
PREVIEW AND
SAVING
->
ALL IMAGES WILL BE LOST IF YOU PRESS THE RED
RECORD BUTTON AGAIN
Hand Unit Triggering
->
Detailed information for adjusting the Hand Unit see
Hand Unit
Make sure, the Hand Unit is connected to the camera and
both are turned on.
Check your image size, frame rate and trigger details in Win-
dow
Camera Control
by clicking three times in the status
line of the “Camera Control” Window.
1.
2.