www.pstechnik.de
5
Safety Notes
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER TO SERVICING TO QUALIFIED SERVICE PERSONNEL.
Warning:
- To reduce the risk of fire or shock hazard, do not expose this equipment to
rain or moisture.
- To reduce the risk of fire or shock hazard, keep this equipment away from
all liquids.
- Use and store this equipment only in locations which are not exposed to
the risk of dripping or splashing liquids. Do not place any liquid containers
on top of the equipment.
- If you are using lasers on set please be careful not to point the ray towards
the lens. A laser that is eye-safe should be in general safe for the sensor as
well. However if you are planning to use lasers we suggest to contact the
technical support before the production, in order to check if the laser can
damage your sensor. Laser damage on the sensor is not covered by warranty
unless there was a written approval by the P+S technical support before the
production.
Caution:
To reduce the risk of fire or shock hazard and annoying interference, use the
recommended accessories only.
FCC Note:
This equipment has been tested and found to comply with the limits for a class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment gener-
ates, uses, and can radiate radio frequency energy. If is not installed and used
in accordance with the instruction manual, it may cause harmful interference to
radio communications.
The operation of this equipment in a residential area is likely to cause harmful
interference. In this case, the user will be asked to correct the interference at
his own expense.
Warning:
To assure continued FCC emission limit compliance, the user must use only
shielded interface cables when connecting to external units. Also, any un-
authorized changes or modifications to this equipment could void the user´s
authority to operate it.
The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of un-insulated
“dangerous voltage” within the product´s enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
