p-light Midi, Installation And Instructions For Use

Page: 15 / 36

www.p-light.com since 2000
15
Elektronic connectors
Term no. Description
1. Battery + 24 V, connected to P-LIGHT®
battery (factory-connected).
2. Battery – Gnd, connected to P-LIGHT®
battery (factory-connected).
3. Input Gnd (-) from truck/trailer Midi =
1.5mm² / Maxi = 2.5mm².
4. Input +24V “Lighting circuit 1” from
trailer’s coupling connector. Midi = 1.5mm²
/ Maxi = 2.5mm².
5. Output +24V “Lighting circuit 1”*,
connected to parking and side lights which
are to remain on while driving, and P-LIGHT®
for short-term parking. NOTE: Must not be
connected to cabling connected to terminal
4 or 6.
6. Input +24V “Lighting circuit 2” from
trailer’s coupling connector. Midi = 1.5mm²
/ Maxi = 2.5mm².
7. Output +24V “Lighting circuit 2”*,
connected to parking and side lights which
are to remain on while driving, and P-LIGHT®
for short-term parking. NOTE: Must not be
connected to cabling connected to terminal
4 or 6.
8. Input +24V “Option” Maxi only, Midi =
no function), direct operation to terminal
9. If, for example, you connect strobes to
terminal 9, it is possible to connect the
trailer’s reversing circuit here, this activates
the strobes when the vehicle is reversing.
9. Output +24V “Option”* e.g. strobes/
work lighting, max. 200W. (Maxi = Activated
by pushbutton 2, Midi = No function).
10. 24V ”AUX”*. 24 V even
if the truck is not connected, nor controlled
by any pushbutton. Intended for operation of
e.g. an external radio control or equipment
with its own keypad, e.g. cabinet lighting,
etc., cable is prepared up to toggle switch
where the required equipment is connected:
Midi = max. 50 W / Maxi = max. 200 W.
* = Fitted with battery/energy monitor, see
the next page for more info.
Maximum number of simultaneous take-offs
Midi = max 100 W / Maxi = max 270 W
Term no. Description
21.No function.
22.No function.
23 -Cable to pushbutton 2 “Option”
(activates terminals 9).
24.+Cable to pushbutton 2 “Option”
(activates terminals 9). “Option” Maxi only,
Midi = no function).
25.-Cable to pushbutton 1 “Parking”
(activates terminals 5 and 7).
26.+Cable to pushbutton 1 “Parking”
(activates terminals 5 and 7).
The cable fuse holder is fitted at the batteries
and the fuse (20A) must be fitted after
connection but before P-LIGHT® is used.
(Note: A spark may occur when the
electronics start and are charged up)