p-light Midi, Installation And Instructions For Use

Page: 10 / 36

Warranty & function!
Extraction of extra power directly from the
batteries is not permitted.
All connected equipment must be connected
as shown in the instructions.
In the case of welding or any other type
of work that may damage electronics
or batteries, these must always be
disconnected before work commences!
Warranty
All P-LIGHT® models are covered by a one-
year product warranty which comes into
force on the purchase date (must be verified).
I.e. When InnoNet AB has been given the
opportunity to determine valid damage
covered by the warranty,
all or parts of P-LIGHT® will be replaced,
but no compensation will be paid for e.g.
workshop costs, downtime, etc.
If warranty repairs are requested, InnoNet
AB or the purchase location/distributor must
always be contacted immediately for advice.
Any costs arising without the permission of
InnoNet AB will not be approved!
IMPORTANT! As the batteries lose capacity
over time (as all chargeable batteries do),
it is necessary to carry out a battery test so
as to know when to replace them. If you
neglect to do this, your P-LIGHT® may not
be capable of remaining on for the time you
were expecting when you parked the trailer
in a short stay park, or it may not be capable
of supplying power to hydraulic equipment,
etc. as required. In other words: replace the
batteries in good time!
IMPORTANT: P-LIGHT® holds type approval
to ECE No. 10. For this to be valid, the
incoming cable connected to terminals 3-7
must be fitted through the installed ferrite
core, as illustrated (not applicable to Midi).
Manufacturer
InnoNet AB - Olvägen 7 - SE-342 50 Vislanda
Phone +46 472-483 83
www.innonet.se
Org.nr 55 66 84-9385
Support
Phone + 46 472-483 93
E-mail: support@innonet.se
Internet: support.p-light.com
www.p-light.com since 2000
10
Important!
P-LIGHT is registered trade mark owned by
InnoNet AB