P.I.T. PBH32-C5, Operation Manual

Page: 6 / 20

Electric Hammer Drill
6
Product Features
The numbering of the product features refers
to the illustration of the machine on the graph-
ics page.
1. Dust protection cap
2. Locking sleeve
3. Mode selector switch
4.
On/Off switch
5. Auxiliary handle (insulated gripping surface)
6. Handle (insulated gripping surface)
7. Mode switch latch
Technical parameter
Model PBH32-C5
Rated voltage
220 V~/50 Hz
Power
1500 W
Rated speed
920 r/min
Impact frequency
4250 ipm
Impact energy 6 J
Max. drilling diameter
(concrete)
Ø32 mm
Weight 8 Kg
Contents of delivery
Electric Hammer Drill 1 pc
Cement drill
（
Ø8/10/12mm) 3 pcs
Auxiliary handle 1 pc
Guide ruler 1 pc
Flat chisel 1 pc
Point chisel 1 pc
Gear lubricant 1 pc
Dust cover 1 pc
Key 1 pc
Instruction manual 1 pc
Note
Technical errors and typographical errors may
be made in the text and numerical designa-
tions of the instructions.
Since the product is constantly being im-
proved, P.I.T. reserves the right to make
changes to the specifications and product
specifications specified here without prior no
-
tice.
Assembly
►
Before any work on the machine itself,
pull the mains plug.
Auxiliary Handle
►
Operate your machine only with the
auxiliary handle. The auxiliary handle
can be set to any position for a secure
and low-fatigue working posture.
- Turn the bottom part of the auxiliary handle
in counterclockwise direction and swivel
the auxiliary handle to the desired position.
Then retighten the bottom part of the aux-
iliary handle by turning in clockwise direc-
tion.
Changing the Tool
The SDS-max drill chuck allows for simple
and convenient changing of drilling tools with-
out the use of additional tools.
The dust protection cap largely prevents the
entry of drilling dust into the tool holder during
operation. When inserting the tool, take care
that the dust protection cap is not damaged.
►
A damaged dust protection cap should
be changed immediately.
We recommend
having this carried out by an after-sales
service.
Inserting (see figure A)
- Clean and lightly grease the shank end of
the tool.
- Push back the locking sleeve and insert
the tool in a twisting manner into the tool
holder. Release the locking sleeve again in
order to lock the tool.
- Check the latching by pulling the tool.
Removing (see figure B)
- Push back the locking sleeve and remove
the tool.
Removal of dust and chips
Dusts from materials such as lead-contain-
ing coatings, some wood types, minerals
and metal can be harmful to one’s health.
Touching or breathing-in the dusts can cause
allergic reactions and/or lead to respiratory
infections of the user or bystanders.
Certain dusts, such as oak or beech dust,
are considered as carcinogenic, especially
in connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
- Provide for good ventilation of the working
place.
-
It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Operation
Starting Operation
►
Observe correct mains voltage! The volt-
age of the power source must agree with
the voltage specified on the nameplate of
the machine.
Setting the operating mode
With the selector switch for drilling/hammer
drilling, the operating mode of the machine is
selected.
To change the operating mode, press the