maintenanCe
Speed System and Bridle lines should be regularly checked and maintained in the correct trim or the
kite will not perform as designed. If they are worn or not to factory specification (+ or - 15mm) they
must be replaced. How To videos and a Bridle Check PDF with all measurements can be found at www.
ozonekites.com
You must inspect all your equipment before and after every use. Check the entire kite including upper
and lower surfaces, line attachment points, speed system and bridles. Immediately replace any worn or
damaged parts with original parts only.
Pre and Post use cHeck list.
•
control system and quick release line: Check for abrasion/wear, if any part is damaged replace it
immediately. Always clean your control system with fresh water after every session, and reload/release
the Quick Release to check the system is functioning correctly. Store your control system with the Quick
Release open. Reload the next time you set up your kite.
•
lines: Check them every time you wind and unwind the lines. If one of them is damaged, change the
corresponding pair.
•
speed system: Check the pulleys and lines for abrasion, if any are damaged change them immediately.
•
bridle lines: Check the bridle lines for abrasion, if any are damaged change them immediately.
•
sail: Check there are no holes or tears in the sail. If your sail is torn, you can repair it with the sticky cloth,
provided in repair kit. To repair the sail, make sure it is clean and dry. Prepare two pieces of sticky cloth,
one for each side of the damaged area. The patch should cover the hole by at least 2cm all round. Lay
flat and stick on both sides.
•
Packing: Dry your kite after use away from the sun and direct heat. Never leave a wet kite in its bag.
Store your kite in a dry place out of the sun. Never wash or clean it with detergent.
PaCkinG
• Land and safely secure the upwind tip with the supplied sand bag, sand, snow or your board.
• Wind the lines around the bar ends. Secure the lines with the elastic.
• Also wind up the Speed System onto the bar – this help reduce bridle tangles.
• Open the centre cell zip on the top surface.
standard bag
• Fold the kite tip on tip and roll the sail from the tip to the centre.
• Fold the Kite to the length of the bar and fasten the webbing tie around the folded kite and bar and
put it into the bag.
1
2
3
4
5
6
7
8
Summary of Contents for Hyperlink V3
Page 1: ...1 Hyperlink V3 Manual ...
Page 24: ......
