Ozone Geo 3, Manual

Page: 16 / 56

14
MODIFICATIONS
Your Ozone Geo 3 was designed and trimmed to give the optimum
balance of performance, handling and safety. Any modification means
the glider loses its certification and will also probably be more dif-
ficult to fly. For these reasons, we strongly recommend that you do
not modify your glider in any way.
QUALITY
At Ozone we take the quality of our products very seriously, all our
gliders are made to the highest standards in our own manufacturing
facility. Every glider manufactured goes through a stringent series of
quality control procedures and all the components used to build your
glider are traceable. We always welcome customer feedback and
are committed to customer service. We will always undertake to fix
problems not caused by general wear and tear or inappropriate use.
If you have a problem with your glider please contact your dealer/dis-
tributor who will be able to decide upon the most appropriate action.
If you are unable to contact your dealer then you can contact us
directly at info@flyozone.com.
the TS-108 standard which specifies minimum tear strength for sky
diving canopies should be made using a Bettsometer. (B.M.A.A. Ap-
proved Patent No. GB 2270768 Clive Betts Sails)
Strength of the lines - An upper, middle and lower A line, along with a
lower B and a lower C (and lower D if applicable) line should be tested
for strength. Each line is tested to breaking point and the value re-
corded. The minimum value is 8 G for all lower A+B lines and 6 G for
all lower remaining lines, calculated from the maximum certified flying
weight of the glider. The added minimum strength for the middle lines
and for the top lines should be the same.
If the breaking strength is too close to the minimum value calculated,
the professional should give a period after which you will have to test
the strength of the lines again.
Lengths of the lines - The overall length (riser lines + mid lines +
upper lines) has to be checked under 5Kgs of tension. The difference
between the measured length and the original length should not
/- 10mm.
The changes that could appear are a slight shrink on the C or Ds and/
or a slight stretch on the A, B. The consequences of these changes
can include a slower trim speed, difficult inflation etc.
Full check - A full visual check should be carried out: All the compo-
nents of the wing (stitching, ribs, diagonals, lines, tabs, ...) should be
checked for signs of detoriation.
Finally, a flight test that confirms that the wing behaves normally
should be carried out by the professional.
IMPORTANT: Take care of your glider and make sure you
have it checked according to the above schedule: This will
ensure you hours of safe flying.