AM5000 Doc. No. 290-062-00 rev. A June 2005
3.0 UNIT DESCRIPTION
The AM5000 series of generator is designed to convert Oxygen found in
the normal air into Ozone. It does this using the Corona Discharge (CD)
principle, where air is blown over a ceramic plate with a stainless steel
electrode, known as an open cell. Each cell has its own power supply,
which delivers high voltage, high frequency electricity to the cell. Each
cell is capable of producing up to 1g/hr of Ozone.
The unit is available in two sizes, the AM5100 and the AM5200.
AM5100 is a single cell design.
AM5200 is a double cell design.
See section 9.0 for more detailed specifications of the units.
4.0 INSTALLATION
These Ozone generators are primarily designed as a portable unit which
is supplied with a UK 3 pin plug, fitted with a 3 Amp fuse and only
requires a 13 Amp 230V 50Hz switched power supply. All electrical
connections should comply with current IEE wiring regulations (BS
7671: 1992 or equivalent).
There are a few guidelines to positioning the unit in order to maximise
its effectiveness:
On a flat, vibration free surface.
Centrally in the area to be treated and if possible at approximately
table height.
The airflow around the unit should not be restricted, a minimum
clearance of 800mm around the unit is recommended.
There should be no risk of the unit being splashed with water, or
other liquids.
The temperature s
hould be between 0ºC to +30ºC.
The relative humidity should not exceed 75% at 20ºC, non-
condensing.
The environment should contain no combustible gases or
aggressive/corrosive chemicals such as bleach, bromine or similar.
Additional fixings are available
separately, to allow connection to a 4”
ducting set-up and Heating, Ventilation and Air Conditioning (HVAC)
ducting. Instructions on how to fit these are supplied with the parts.
