Ozone Addict 2, Pilot'S Manual

Page: 8 / 44

If you want better speed, precise handling, if you generally fly in mountains and/or in
strong conditions, you should chose to fly in the top part of the weight range.
If you want a better sink rate, if you generally fly in flat lands and/or in weak conditions,
you may choose to fly in the bottom part of the weight range. Remember, you can
always add ballast for when conditions are stronger.
BASIC FLIGHT TECHNIQUES
To familiarise yourself with the glider it is a good idea to perform practice inflations and
small flights on a training hill. This will enable you to set up your equipment correctly. If
in any doubt please get advice and help from your local dealer or instructor.
Preparation
Lay out the Addict 2 on its top surface in a pronounced arc, with the centre of the wing
higher than the tips. Lay out the lines one side at a time. Hold up the risers and starting
with the brake lines, pull all lines clear. Repeat with the C, B and A lines, laying the
checked lines on top of the previous set, and making sure no lines are tangled, knotted
or snagged. Mirror the process on the other side.
Take-off checklist:
1. Check reserve parachute - pin in and handle secure
2. Helmet on and fastened
3. All harness buckles closed - check leg-loops again
4. Karabiners and maillons tight
5. Holding the A's and your brake handles
6. Leading edge open
7. Aligned directly into wind
8. Airspace and visibility clear
Launching
Your Addict 2 will launch with either the forward or reverse techniques.
Whilst inflating your wing, you should hold both of the A risers (main A and baby A) on
each side. Once clipped in, and you have gone through the take-off check list (above),
stand central to the wing to ensure an even and progressive inflation.
Forward Launch - Nil to Light winds
When the wind is favourable, move forward positively: your lines should become tight
within one or two steps. The Addict 2 will immediately start to inflate. You should
maintain a constant pressure on the risers until the wing is overhead.
Do not pull down or push the risers forward excessively, or the leading edge will
deform and possibly collapse making taking-off more difficult and potentially
dangerous.
Move smoothly throughout the entire launch, there is no need to rush or snatch at it.
You should have plenty of time to look up and check your canopy before committing
yourself.
Once you are happy that the Addict 2 is inflated correctly, accelerate smoothly off the
launch.
Reverse Launch -Light to Strong Winds
Lay out your Addict 2 as you would for the forward launch. However, this time turn to
face the wing, passing one entire set of risers over your head as you turn. Now you
can pull the Addict 2 by its A-risers. Once the wing is overhead, brake it gently, turn
and launch.
In stronger winds, be prepared to take a few steps towards the glider as it inflates.
This will take some of the energy out of the glider and it will be less likely to overfly
you. This reverse-launch technique can be used in surprisingly light winds too.
IMPORTANT : Never take off with a glider that is not fully inflated or if you are
not in control of the pitch/roll of your wing.
Practice ground handling a lot! It's great fun, and will give you a much better feel for
your Addict 2’s flight characteristics. It will also improve your overall enjoyment of
flying by making your launches easier.
In Flight Characteristics
The Addict 2 shows no unusual flying characteristics, consequently it is suitable for a
very wide range of pilot. In turns, the Addict 2 is smooth and co-ordinated, on glides it
remains solid and well pressured, even through the accelerated speed range. It has a
very high resistance to both collapses and stalls. However, to get the most out of your
Addict 2 we advise you to consider the following information:
Normal Flight
Flying at 'trim speed' (hands-up), the Addict 2 will achieve its 'best
glide' speed for normal air. You should fly at this speed when gliding downwind or
when the air is not excessively sinking.
For better penetration in headwinds and improved glide performance in sinking
air, crosswinds or headwinds, you should fly faster than trim speed by using the
accelerator system. Using up to half bar does not degrade the glide angle or stability
significantly and will improve your flying performance, as you will reach the next
thermal faster and higher. At full speed the Addict 2 is stable; however we recommend
that you do not fly at full speed close to the ground or in turbulence.
By applying the brakes approximately 30cm, the Addict 2 will achieve its minimum-
sink rate; this is the speed for best climb and is the speed to use for thermalling and
ridge soaring.
Turning
To familiarize yourself with the Addict 2 your first turns should be gradual and
progressive.
6