SETTING UP (cont.)
5
5. To raise the opposite front leg first remove
the front leg support brace (13) from the
holding bracket (Fig. 5).
6. Fully raise the opposite front leg (Fig. 6)
ensuring the locking pin clicks into the
opposite pin hole.
7. Swing the support brace (13) to the opposite
front leg and place it into position between
the front support brace locking knob (14)
and front leg.
8. Ensure the brace is positioned between the
washer and front leg.
9. Tighten the support brace locking knob (14)
to secure the support brace into position
(Fig. 7).
10. Repeat steps 3 to 9 for the rear legs (12) until
all 4 legs are in the upright position and
secured with the support braces (Fig. 8).
11. Prior to turning over the Uni-Jaws ensure
that all 4 locking pins (9 & 10) have clicked
into the correct holes and the support braces
(13 & 15) are locked in with the support
brace locking knobs (14 & 16).
12. Carefully turn over the Uni-Jaws and place it
into the upright position (Fig. 9).
Fig. 6
Fig. 8
Fig. 9
Fig. 7
Fig. 5
UJC-860 manual.qxd 9/27/09 12:32 PM Page 6
