2. CHANGING ACCESSORIES CONT.
3. FLEXIBLE SHAFT
1. Remove the shaft collar.
2. Loosen the collet nut.
3. Raise the handle
end of the flexible
shaft & shake
gently until the
inner flexible shaft
protrudes from the
fitting collar.
5. Insert the inner flexible shaft into the collet then tighten the collet
nut.
Locating a cutting/sanding disc
1. Remove the screw from the
end of the disc holder.
2. Fit the fibre flange either
side of the cutting disc, then
insert the screw.
3. Tighten the cutting disc
onto the cutting disc holder.
Locating a sanding drum
1. Loosen the screw on the
top of the sanding drum
holder.
2. Slide the sanding drum
onto the sanding drum
holder.
a
b
6. Screw the flexible
shaft fitting collar
onto the rotary tool.
7. Insert the hex key into the
hole on the handle.
Note:
Do not over-tighten the screw as it could result in damage to
the cutting disc.
3. Tighten the screw until
the sanding drum sleeve
is secured.
a
b
8. Loosen collet nut then insert
shank of accessory into collet.
9. Tighten collet nut and check all fittings to ensure they are
securely fastened.
