ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
KNOW YOUR PRODUCT
1. USING THE DEPTH ROD
The depth rod allows you to drill to a predetermined depth.
1 SDS
+
Accessory Holder
2 Accessory Locking Sleeve
3 Depth Rod Locking Hole
4 Side Handle
5 Side Mode Selector
6 Grease Cap
7 Rear Mode Selector
8 On/Off Switch
9 Rear Handle
ROTARY HAMMER DRILL
10 Depth Rod
11 3 x SDS
+
150mm Drill Bits
12 1 x SDS
+
Flat Chisel
14 x 250mm
13 1 x SDS
+
Point Chisel
14 x 250mm
14 Dust Cover
15 High Temperature Grease
16 Pin Spanner
ACCESSORIES
SETUP & PREPARATION
WARNING!
ENSURE THE TOOL IS DISCONNECTED
FROM THE POWER SUPPLY BEFORE PERFORMING
ANY OF THE FOLLOWING OPERATIONS.
Required
Drilling
Depth
1 Loosen the depth rod
securing nut then insert
depth rod.
4 Drill the hole until
the end of the
depth rod touches
the workpiece.
3 Tighten the depth
rod securing nut to
lock the depth rod
into place.
2 Adjust the depth
rod so the drill bit
extends beyond the
end of the depth
rod to the required
drilling depth.
1
10 11 12 13 14 15 16
2 3
4 5 6 7 8 9
