![background image](http://html1.mh-extra.com/html/ozito/rhd-2100/rhd-2100_instruction-manual_1666661005.webp)
MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLE SHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• Keep the ventilation vents of the drill clean at all times.
• After each use, blow air through the drill housing to ensure it is free from all
dust particles which may build up. Build up of dust particles may cause the
drill to overheat and fail.
• If the enclosure of the drill requires cleaning, do not use solvents but a moist
soft cloth only. Never let any liquid get inside the drill; never immerse any part
of the drill into a liquid.
Carbon Brushes
When the carbon brushes wear out, the drill will spark and/or stop. Discontinue
use as soon as this happens. They should be replaced prior to recommencing
use of the drill. Carbon brushes are a wearing component of the drill therefore
not covered under warranty. Continuing to use the drill when carbon brushes
need to be replaced may cause permanent damage to the drill. Carbon
brushes will wear out after many uses but when the carbon brushes need to
be replaced, take the drill to an electrician or a power
tool repairer for a quick and low cost replacement.
Always replace both carbon brushes at the same
time.
Note: Ozito Industries will not be responsible for any
damage or injuries caused by the repair of the drill by
an unauthorised person or by mishandling of the drill.
Brush Holder (pair)
Carbon Brush (pair)
Brush Cap
Switch
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
Problem
Cause
Remedy
Rotary Hammer
Drill is not working
No power supplied
Make sure all plugs are
connected and power
outlet is in working order
Motor brushes binding in
brush holders.
Clean brush holders.
Remove carbon dust by
using compressed air to
blow out brush dust
Excessive
sparking visible
through air vents
Carbon brushes have
worn out
Replace carbon brushes
as per maintenance
section.
Warning
Read instruction manual
Wear eye protection
Double insulated
/min Revolutions or
reciprocation per minute
n
o No load speed
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
Diameter
Regulator compliance mark
Wear ear protection
mm
Millimetres