background image

1

PTP-425

  7.  STARTING ENGINE

  6. PRE-OPERATION INSPECTION

TRANSFER PUMP

1.7HP

4 Stroke OHV

TRANSFER PUMP

1.7HP

4 Stroke OHV

ON

CHOKE

1.   Move the fuel lever 

to the right “ON” 

position.

Note:

 No choke is required 

if the engine is warm. Make 

sure the choke is in the left 

position when starting a 

warm engine

5.   Grip the recoil starter and 

slowly pull until resistance 

is felt, then pull the recoil 

starter rapidly. 

Allow the rope to rewind 

slowly and if necessary, 

repeat this procedure until 

the engine starts.

3.   Turn the on/off switch 

to the ON (I) position.

6.   Once started move the 

choke lever to the left.

TRANSFER PUMP

1.7HP

4 Stroke OHV

TRANSFER PUMP

1.7HP

4 Stroke OHV

ON

CHOKE

TRANSFER PUMP

1.7HP

4 Stroke OHV

TRANSFER PUMP

1.7HP

4 Stroke OHV

ON

CHOKE

Air Filter

Starting the Engine

Spark Plug

1.   Ensure the filter 

is free from any 

debris.

2.   If necessary clean or replace the filter by following the steps 

outlined in the maintenance section of this manual.

2.   To remove and install the spark plug refer to the 

maintenance section of this manual.

1.   Make sure the electrode 

is clean and the air gap 

is correct (refer to the 

specs of the spark plug 

manufacture).

The air filter must always be in perfect working order, to 

prevent debris and dust from being sucked into the engine thus 

reducing the efficiency and life of the machine.

Use only the spark plugs that are recommended for this petrol 

pump: Torch - E5RTC, Champion - RL95YC, NGK - BPR5HS. 

Note:

  

Using a spark plug other than that specified could lead to 

serious engine damage.

WARNING!:

 NEVER ATTEMPT TO FUEL THE 

PUMP IF THE FUEL SYSTEM COMPONENTS ARE 

DAMAGED OR ARE LEAKING. 

WARNING!:

 NEVER PLACE FLAMMABLE 

MATERIAL CLOSE TO THE ENGINE MUFFLER.

2.   Move the choke lever 

to the right “CHOKE” 

position.

4.   Move the throttle lever 

down             (fast position).

TRANSFER PUMP

1.7HP

4 Stroke OHV

TRANSFER PUMP

1.7HP

4 Stroke OHV

ON

CHOKE

TRANSFER PUMP

1.7HP

4 Stroke OHV

TRANSFER PUMP

1.7HP

4 Stroke OHV

ON

CHOKE

7.   Allow to run for 30-60 

seconds before adjusting 

throttle as the engine may 

stall.

Summary of Contents for PTP-425









Reviews: