![background image](http://html.mh-extra.com/html/ozito/ocba-1000/ocba-1000_instruction-manual_1666788004.webp)
BATTERY
TESTER
CLAMPS
CRANKING
CHARGING
LOW VOLTAGE
•
BATTERY
CLAMPS
CRANKING
CHARGING
LOW VOLTAGE
BATTERY
TESTER
CLAMPS
CRANKING
CHARGING
LOW VOLTAGE
CLAMPS
CRANKING
CHARGING
LOW VOLTAGE
BATTERY
CLAMPS
CRANKING
CHARGING
LOW VOLTAGE
CLAMPS
CRANKING
CHARGING
LOW VOLTAGE
•
CLAMPS
CRANKING
CHARGING
LOW VOLTAGE
•
3. BATTERY ANALYSIS
OPERATION
OCBA-1000
Battery Test
Before testing battery, if it is in a vehicle, turn off all vehicle accessory
loads such as lights, air conditioning, radio etc. Ensure battery is fully
charged before testing.
Only test a single battery at a time with the Battery Test Function. If the
battery requires repeat testing using the battery test function, after
1 minute of testing, allow the battery tester to rest for 10 minutes before
proceeding.
Note:
If the vehicle has been running before testing, the battery holds
a surface charge. Turn on headlights for 30 seconds to remove surface
charge. Let battery rest for one minute before starting to test.
1. Connect the battery tester to the battery,
following the instructions specified in
the
"Battery Connection"
section.
2. The digital display will show the battery
voltage, press the "Enter" button to the
next step.
Note:
If the Low Voltage LED lights up,
disconnect the battery tester and charge
the battery before attempting the "Battery
Test" again.
3. Press the "Up" and "Down" to select "batt" battery and press "Enter"
button.
4. Press the "Up" and "Down" to select
the battery type REGU or AGM (REGU -
standard wet battery / AGM - VRLA, GEL,
AGM, EFB etc sealed battery).
5. Press "Enter" button to confirm
selection.
6. Press the "Up and "Down" buttons to
select the desired battery rating SAE ,
DIN, IEC , EN, CA, MCA, JIS, BCI, CCA,
GB. For general testing select CCA.
7. Press "Enter" button to confirm selection.
8 Press the "Up" and "Down" buttons to
input the battery cold cranking amps
(CCA). Refer to the battery rating label of
the battery being tested.
9. Press "Enter" button to confirm
selection and start the test.
10. Battery analysis will begin.
11. When the test is complete, the digital
display will show the CCA value. The
test result LED will also illuminate.
– Green LED =
battery is ok.
– Yellow LED =
battery is weak.
– Red LED =
battery is bad. Need to
change the battery immediately.
12. Turn engine off before disconnecting
from the vehicle battery.
Check the battery terminal clamps are correctly connected to the lead acid
battery. Twist the terminal clamps slightly to ensure a good connection. It
is recommended that an assistant be present to assist with all tests.
Cranking Test
With the battery terminal clamps correctly connected and before having
your assistant start the engine, turn off all vehicle accessory loads such as
lights, air conditioning, radio etc.
1. Press the "Down" button to select the
system test CRAN.
2. With CRAN on the digital display, press
"Enter" button.
3. Have your assistant start the engine.
4. When the test is complete, the digital
display will show the cranking voltage.
The test result LED will also illuminate.
–Green LED =
When starting system is ok.
– Cranking Error LED=
When starting
system is abnormal and difficult to start.
5. Turn engine off before disconnecting
from the vehicle battery.