TROUBLESHOOTING
The Depth Adjustment Locking Knob Will Not
Tighten
The guide wheel cutting arm may not be located correctly in 1 of the 3
preset cutting depths. Move the guide wheel cutting arm up or down into a
preset location and then tighten the depth adjustment locking knob.
The Edger Will Not Start
•
Ensure the edger is connected to a sufficient power supply.
•
Ensure that the lock-off switch is fully pressed down and then
squeeze
the trigger to start the lawn edger.
CARING FOR THE ENVIRONMENT
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito customer service
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
DESCRIPTION OF SYMBOLS
MAINTENANCE
• Keep the ventilation vents of the tool clean at all times, if possible,
prevent foreign matter from entering the vents.
• After each use, blow air through the motor housing to ensure it is
free from all dust particles which may build up. Build up of dust
particles may cause the unit to overheat and fail.
• If the enclosure of the tool requires cleaning do not use solvents
but a moist soft cloth or soft brush only. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
NOTE:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the tool by an unauthorised person or
by mishandling of the tool.
2. Turn the small spanner
clockwise and remove the
nut, outer flange and blade.
Note:
Ensure the nut and outer
flange are clean of any dirt or
grass prior to fitting.
4. Fit the nut and tighten firmly
in an anti-clockwise direction
using the 2 supplied
spanners.
1. Lay the edger on
its side and place
the large supplied
spanner over the
outer blade flange
and the small
spanner on the nut.
3. Fit the new blade
over the inner flange,
then the outer
flange, ensuring they
are located correctly
and in the correct
direction.
Changing the Cutting Blade
General Maintenance
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Regulator compliance mark
Remove plug from the mains immediately
if cabel is damaged or cut.
Do not expose to or
operate in the rain
V
Voltage
Hz
Hertz
~
Alternating current
/min
Revolutions or
reciprocation per minute
Double insulated
Read operating instructions before use
Wear hearing protection
Wear eye protection
Thrown objects
Rotating cutting blade
Direction of edger blade rotation
Warning
W
Watts
dB
Decibel (noise) rating
IPX4
Ingress protection rating
n
o
No load speed
Keep bystanders at
a safe distance
Disconnect the power and
remove the plug from the
power supply before caring
out any maintenance. Keep
the extension cord away
from the blade.
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your local
council authority for recycling advice.
