ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
KNOW YOUR PRODUCT
SETUP & PREPARATION
1. ASSEMBLY
ELECTRIC LAWN EDGER
1
2
3
4
5
6
7
8
9
10
11
1. Switch Handle
2. Front Handle
3. Locking Knob
4. Lower Tube
5. Motor Housing
6. Lock-Off Switch
7. Cord Retainer
8. On/Off Trigger
9. Handle Locking Knob
10. Upper Tube
11. Blade Guard
12. Depth Adjustment Knob
13. Dual Cutting Blade
14. Guide Wheel
3. Place the upper tube onto
the lower tube, fit the bolt
through both tubes from
the underside and secure
with washer and locking
knob.
1. Align the groove on the
lower tube with the lug in
the motor housing and
push in until it clicks into
place.
Note:
Take care not to
damage the cable while
inserting.
4. Place the switch handle
tube onto the upper tube,
fit the bolt through both
tubes from the underside
and secure with washer
and locking knob.
2. Secure in place by
tightening the 2 screws
on each side.
Fitting the Front Handle
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
1. Place the front handle onto
the switch handle. Pass
the bolt through the handle
and secure with the locking
knob.
ACCESSORIES
15. Blade spanners x 2
16. Handle Fasteners x 2
12
13
14
15
16
Tube Assembly
