2. ATTACHING LASER TO TRIPOD
3. ADJUSTING THE TRIPOD
Adjusting the Height of the Laser
The tripod allows you to set up the laser in a specific position and easily
make adjustments to the height, angle and tilt of the unit.
1 Open up the 3 legs of the
tripod to stabilise the platform.
a
b
a
b
2 Remove the mounting
plate from the tripod
by lifting on the quick
release lever.
3 Align the 1/4” mount at the
base of the laser unit with the
1/4” screw at the top of the
tripod.
4 Rotate the laser unit
clockwise to fasten the
unit to the mounting
plate securely.
5 Attach mounting plate with
laser to tripod by lifting the
quick release lever, then
slotting mounting plate into
tripod opening. Release lever
to secure.
Note:
Make sure the laser is
pointing perpendicular to
the angle adjusting handle.
7 To remove the laser unit from
the mounting plate, rotate the
unit anti-clockwise.
6 To remove the laser
unit from the tripod,
lift the quick release
lever at the top of
the tripod and then
raise the laser and
mounting plate from
the tripod.
1 Extend the 3 legs of the tripod
by unlocking the leg locking
levers and raising the legs.
Note:
Ensure the locking levers
are locked once desired
height is achieved to
secure the tripod.
2 To raise the laser further, wind
the height locking knob anti-
clockwise to loosen, then raise
the laser by winding the height
adjustment handle.
Note:
Ensure the height locking
knob is secured after
adjusting, by rotating
clockwise.
