12
ASSEMBLY
Assembling the handle (3) to telescopic shaft (6)
1. Align the big lug and small lug of the handle (3)
with the big groove and small groove in the
telescopic shaft (6) (Fig. 4).
Caution:
Do not use excessive force when inserting
the handle (3). If the handle (3) does not slide in
easily onto the telescopic shaft (6), it is not being
inserted correctly and could cause damage to the
handle (3) and/or telescopic shaft (6).
2. Firmly push the handle (3) onto the telescopic shaft till it locks into place.
Note:
The handle (3) and the cutting head (9) cannot be removed once it has been
assembled to the telescopic shaft (6).
Assembling the cutting head (9) to telescopic shaft (6)
1. Align the lug of the cutting head (9) with the
groove in the telescopic shaft (6) (Fig. 5).
Caution:
Do not use excessive force when inserting
the cutting head (9). If the cutting head (9) does not
slide in easily onto the telescopic shaft (6), it is not
being inserted correctly and could cause damage to
the cutting head (9) and/or telescopic shaft (6).
2. Firmly push the cutting head (9) onto the
telescopic shaft (6) till it locks into place.
Installing the secondary handle (4)
1. Fit the mounting bracket (5) onto the telescopic
shaft (6), ensure the lug locates into the groove
of the telescopic shaft (6) (Fig. 6).
Note:
You will need to carefully flex the mounting
bracket (5) just enough to slip over the shaft (6). Do
not over flex as this can damage or break the
mounting bracket (5).
2. Place the adjustable secondary handle (4) on the
mounting bracket (5) (Fig. 7).
Fig. 4
Fig. 5
Fig. 6
Fig. 7
