Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your local
council authority for recycling advice.
MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Note:
The LED light is not replaceable.
•
When not in use, the tool should be stored in a dry, frost free
location, keep out of children’s reach.
•
If the housing of the tool requires cleaning, do not use solvents
but cloth only.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by repair of the tool by an unauthorised person or by
mishandling of the tool.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
for further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
Warning
Read instruction manual
mW Milliwatt
Recycle battery
Do not incinerate
Transformer Energy
Rating (MEPS)
Ah
Amp hour
Laser Light Laser Radiation
Electrical Emissions
Conformity (EMC)
V
Volts
Hz
Hertz
ac/~ Alternating current
W
Watts
Direct current
dc/
Do not put in the rubbish
Regulatory Compliance Mark
(RCM)
Polarity
Do not get battery wet
Indoor use only
Do not use or store battery in
temperatures exceeding 50ºC
Laser does not turn on
The batteries may be depleted. Ensure you have inserted 4 AA batteries
with a full charge.
Make sure the batteries are in the correct direction as indicated by the
embossing in the battery compartment.
The indicator light is glowing red
This indicates that the auto-levelling feature is not in use. This is desired if
you require a line at a angle that is not level.
If this occurs when attempting to produce a level line, it means the angle
of the unit is outside the auto-levelling range. You will need to reset the
tripod to obtain a closer angle to level.
Laser line is flashing
This indicates that the product is outside of auto-levelling range. This is
desired if you require a line at a angle that is not level. To product a level
line, straighten the product on the tripod until green indicator light shows
on top of the product.
