7
WELDER SAFETY WARNINGS
WARNING!
The appliance is not to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction.
Young children should be supervised to ensure that they do not play with the appliance.
Before connecting a tool to a power source (mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on the nameplate of the tool. A power source
with a voltage greater than that specified for the tool can result in serious injury to the user, as well as
damage to the tool. If in doubt, do not plug in the tool. Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
• Under no circumstances should the housing of the welder be opened.
• Never attempt to repair or modify the welder.
• Screen off the work place to protect others working nearby from UV rays.
• Do not use the welder in damp or wet conditions.
• Do not use the welder for pipe thawing.
• Do not use cables with worn insulation or loose connections.
• Disconnect from the power supply before replacing welding wire.
• Avoid direct contact with the welding circuit.
• Never pull on the welding leads or the power cord to move the welder.
• Ensure the welding materials are securely clamped down/fastened before welding.
• Always place welding torch and clamp on flat stable surface when not in use.
• Never put the welding torch down until the welder is switched off.
• Store all spare welding wire in a safe place, away from the welding area.
• Welding materials with contaminated surfaces may generate toxic fumes. Ensure the surface is clean
before welding. Avoid operating on materials cleaned with chlorinated solvents or near such solvents.
• Do not weld metal equipment that holds/contains flammable materials, gases or liquid combustibles.
• Zinc-plated or galvanized material should not be welded as the fumes created are highly toxic.
• Do not weld painted / oiled materials. Ensure all welding surfaces are stripped / cleaned down to the
bare metal.
• Always check the welding material before welding to see if it the material is compatible with self
shielded flux cored arc welding.
• Do not use the welder near food or food preparation areas.
• Do not weld cadmium plated steel. Always check the welding material for control measure before
welding
• Use only one welder to weld at all times.
• Only connect the welding machine to an earthed electric network.
• Never touch live parts or the welding rod with wet hands/gloves/clothing.
• Ensure there is a level of insulation (welding mats) between yourself and the ground as well as the
workpiece when welding.
• Ensure cables or welding electrode holder are not squashed by heavy objects and that they are not
exposed to sharp edges or a hot work piece.
