Spark Plug Servicing
Use only good quality spark plugs. To ensure proper engine operation,
the spark plug must be properly gapped and free of deposits.
1. Pull out the spark plug lead.
2. Remove the spark plug using
the spark plug wrench supplied
by turning it anti-clockwise.
3. Clean the electrode with a
metal brush and remove any
carbon build-up or replace the
spark plug. Set the electrode
gap to 0.6 - 0.7mm
0.6 - 0.7mm
4. Install the spark plug carefully by hand, to avoid cross threading.
Tighten it securely with Spark plug wrench.
5. Reinstall the spark plug lead.
Fuel Filter
A dirty fuel filter will restrict fuel
flow to the carburettor. Replace
the fuel filter if it becomes
noticeably discoloured.
The fuel filter can be found
under the fuel cut off tap.
TROUBLESHOOTING
Circuit Breaker Trips During Use
If the circuit breaker trips during use, it usually indicates faulty electrical
equipment or cords. Follow the steps below to determine if the issue
lies with the circuit breaker or with equipment/cords.
1. Disconnect loads, reset and test the circuit breaker as described in
the
“Checking the Residual Current Circuit Breaker”
section of
this manual.
2. Let the generator run without any loads for 1 minute.
3. If the circuit breaker trips in the 1 minute period, do not continue
to use the generator. Shut the generator down and contact Ozito
Customer Service.
4. If the circuit breaker tests correctly, the electrical equipment or
extension cords may be faulty. Replace faulty electrical equipment
and cords before further use. Have qualified personnel check all
electrical equipment and cords for any defects.
