background image

1

2.  FUEL

3.  STARTING & STOPPING

OPERATION

Refuelling the Generator

Fuel Consumption

Preparing to Start

2.   Set the engine switch to 

ON.

1.   Set the fuel tap to the “ON” 

position as shown.

3.   Adjust the choke to suit the current 

conditions.

COLD START:

 

If the weather is cold, 

push the choke all the way to the left 

into the “ON” position.

WARM START:

 

If the weather is warm 

or the generator has recently been 

used, push the choke all the way to 

the right into the “OFF” position.

OFF

ON

1.   Switch off engine by 

moving the engine switch 

to the OFF position. 

2.   Remove the fuel cap by 

rotating in a anti-clockwise 

direction.

3.   Add fuel to the tank (91 RON 

Unleaded Petrol). Do not 

overfill the fuel tank, check 

the fuel gauge on the fuel 

tank. Do not use ethanol 

blended fuels. Fuel tank 

capacity is 5L.

E

F

4.   After refuelling, make sure the fuel cap is closed properly and 

securely.

WARNING!

 

BE CAREFUL NOT TO SPILL FUEL WHEN 

REFUELLING. SPILLED FUEL OR FUEL VAPOUR MAY 

IGNITE. IF ANY FUEL IS SPILLED, MAKE SURE THE AREA 

IS DRY BEFORE STARTING THE ENGINE.

WARNING!

 

KEEP AWAY FROM CIGARETTES, SMOKE AND 

SPARKS WHEN REFUELLING THE GENERATOR. ALWAYS 

REFUEL IN A WELL-VENTILATED LOCATION.

Before starting the engine, disconnect all appliances from the 

generator.

OFF

ON

CHOKE LEVER

Starting the Engine

Before starting the engine, disconnect all appliances from the 

generator.

1.   Follow steps 1 to 3 in the 

“Preparing to Start”

 section above.

2.   Hold the generator steady 

with one hand. With the 

other hand, pull slightly on 

the recoil starter until you 

feel resistance and then 

pull hard and swiftly. Do 

not let the recoil starter 

retract by itself, guide it 

back by hand.

3.   Once started push the choke all the way to the right into the “OFF” 

position. 

Note:

 You may need to pull on the recoil starter a few times until the 

generator starts.

WARNING!

 

PETROL IS VERY FLAMMABLE. DO NOT 

SMOKE OR CAUSE ANY SPARKS OR FLAMES NEAR 

FUEL. MAKE SURE THAT YOU STOP THE ENGINE 

AND ALLOW IT TO COOL BEFORE REFUELLING THE 

GENERATOR. SELECT AN OPEN OUTDOOR AREA FOR 

FUELLING AND MOVE AT LEAST 3M AWAY FROM THE 

FUELLING POINT BEFORE STARTING THE ENGINE.

Load

Fuel Consumption

Run Time (full tank)

2200W (full load)

1500mL/h

3 hours

1100W (half load)

1026mL/h

4.5 hours

Summary of Contents for IGP-2500









Reviews: