Low Oil Indicator (YELLOW)
If the oil level becomes low while the generator
is running, the oil level LED will light up yellow.
The generator will also switch off automatically to
prevent damage to crank case.
Follow the steps for checking the oil level, add
engine oil and restart the generator as normal.
AC Power Indicator (GREEN)
The green indicator LED will light up when power
is ready to be supplied to the AC power sockets.
Overload Indicator (RED)
If the generator is overloaded or there is a short
in the connected appliance, the red overload
indicator will light up and current to the AC outlets
will be cut-off.
Substantial overloading that continuously trips
the generator may cause irreversible damage to
the unit. Marginal overloading that temporarily
lights up the overload indicator may shorten the service life of the
generator.
WARNING!
STOP THE GENERATOR IF THE OVERLOAD
INDICATOR LIGHTS UP AND INVESTIGATE THE
OVERLOAD SOURCE.
WARNING!
ENSURE THAT ALL APPLIANCES ARE IN
GOOD WORKING ORDER BEFORE CONNECTING THEM
TO THE GENERATOR. IF AN APPLIANCE BEGINS TO
OPERATE ABNORMALLY, BECOMES SLUGGISH OR
STOPS SUDDENLY, SWITCH THE GENERATOR OFF &
DISCONTINUE USE OF THE APPLIANCE.
Follow the steps below to reset the generator after an overload.
1. Flip the AC and engine
power switches off.
2. Disconnect all appliances.
3. Restart the generator as
described in the ‘
Starting
The Generator
’ section.
4. Connect the appliances one at a time. If the overload switch
trips again then the appliance is faulty - contact Ozito Customer
Service.
3. INDICATORS & ALERTS
2000W
PETROL INVERTER GENERATOR
4 STROKE 119CC ENGINE
2000W
INVERTER
TECHNOLOGY
2x
AC SOCKET 1
USB PORTS
AC SOCKET 2
OVERLOAD
AC OUTPUT
AC
IF OVERLOADED
RESTART ENGINE TO RESET
AC POWER
I
0
I
0
I
0
240V
1
240V
2
FUEL ECONOMY
ENGINE POWER
AUTOMATIC ENGINE SHUT OFF
REFILL MOTOR OIL
LOW OIL
OFF
ON
OFF
ON
OFF
ON
LOW OIL
Starting Watts (aka Surge Watts)
You may find that even though the appliance you wish to connect
to the generator is below the rated power, the generator overloads.
Some appliances require a higher power than noted on the
appliance for start up; this is called starting watts or surge watts.
Some examples are listed below.
Appliance
Running Power
Start-up Power
Light
70W
70W
Airless Sprayer
650W
1300W
Refrigerator
700W
2000W
Water Pump
800W
2000W
Air Compressor
1100W
4000W
Circular Saw
1200W
2100W
Heater
2000W
2000W
Mitre Saw
2100W
3200W
Electric Stove
2400W
2400W
*Table details are approximate. Always check your appliance for
accurate wattage.
WARNING!
THE START-UP POWER OF CONNECTED
DEVICES SHOULD NOT EXCEED THE MAX. POWER
RATING OF THE GENERATOR. THE RUNNING POWER
SHOULD NOT EXCEED THE RATED POWER.
Extension Cord
When an extension cable is required, be sure to use a rubber
sheathed flexible cable. Limit length of extension cables to:
• 60m for cables of 1.5mm² and
• 100m for cables of 2.5mm
2
.
2000W
PETROL INVERTER GENERATOR
4 STROKE 119CC ENGINE
2000W
INVERTER
TECHNOLOGY
2x
AC SOCKET 1
USB PORTS
AC SOCKET 2
OVERLOAD
AC OUTPUT
AC
IF OVERLOADED
RESTART ENGINE TO RESET
AC POWER
I
0
0
I
I
0
240V
1
240V
2
FUEL ECONOMY
ENGINE POWER
AUTOMATIC ENGINE SHUT OFF
REFILL MOTOR OIL
LOW OIL
OFF
ON
OFF
ON
OFF
ON
LOW OIL
2000W
PETROL INVERTER GENERATOR
4 STROKE 119CC ENGINE
2000W
INVERTER
TECHNOLOGY
2x
AC SOCKET 1
USB PORTS
AC SOCKET 2
OVERLOAD
AC OUTPUT
AC
IF OVERLOADED
RESTART ENGINE TO RESET
AC POWER
I
0
0
I
I
0
240V
1
240V
2
FUEL ECONOMY
ENGINE POWER
AUTOMATIC ENGINE SHUT OFF
REFILL MOTOR OIL
LOW OIL
OFF
ON
OFF
ON
OFF
ON
LOW OIL
2000W
PETROL INVERTER GENERATOR
4 STROKE 119CC ENGINE
2000W
INVERTER
TECHNOLOGY
2x
AC SOCKET 1
USB PORTS
AC SOCKET 2
OVERLOAD
AC OUTPUT
AC
IF OVERLOADED
RESTART ENGINE TO RESET
AC POWER
0
I
0
I
0
I
240V
1
240V
2
FUEL ECONOMY
ENGINE POWER
AUTOMATIC ENGINE SHUT OFF
REFILL MOTOR OIL
LOW OIL
OFF
ON
OFF
ON
OFF
ON
LOW OIL
IGP-2018
Summary of Contents for IGP-2018
Page 24: ......