1
ELM-1000
3. HOW TO MOW
1. To start, press and hold the lock-
off button.
2. Pull the Start/stop lever towards
the handle, the motor will start,
then release the lock-off button
3. Release the Start/stop lever to
stop the mower.
•
Always use an approved extension lead suitable for power input of
this tool.
• Heavy duty power leads recommended.
• While using your lawn mower always wear substantial footwear
and long trousers.
•
Make sure the lawn is clear of sticks, stones, wire and debris; they
could be thrown by the blade.
•
Before using the lawn mower and after any impact, check for signs
of wear or damage and repair as necessary.
• Replace a worn or damaged blade together with the blade bolt to
preserve balance.
To prevent accidental start up of the motor the mower is fitted with a
dual action switch
Switching On/Off
1
2
WARNING!
THE BLADE WILL COAST AFTER
THE SWITCH HAS BEEN RELEASED. BE AWARE
OF THE NECESSARY TIME IT TAKES FOR THE BLADE
TO STOP COASTING. DO NOT ATTEMPT TO STOP THE
BLADE.
Start mowing the edge of the lawn
nearest to the power point so the
lead is laid out on the lawn you have
already cut.
For best grass collection, always mow in a straight line; do not swing
the lawn mower from side to side.
Mowing long thick grass may cause the motor speed to drop; you will
hear a change in the motor sound. If the motor speed drops you may
overload your lawn mower, which may cause damage. When mowing
in long thick grass first cut with the cutting height set in the highest
position, this will help reduce the load.
Do Not Overload the Mower
The tool is recommended for use with a residual current device with a
rated residual current of 30mA or less.
WARNING!
KEEP
EXTENSION CORD
AWAY FROM BLADES.
Overload Protection
The mower has an internal cut off switch which will stop the operation
of the motor temporarily if overloaded. This cut off switch will suddenly
stop the motor from operating should the motor become too hot
during the operation of the mower.
First disconnect the mower from the power supply and inspect blade
for any obstructions.
A wait of up to 2 minutes in cooling time, or longer depending on
ambient temperature and the operation being performed, before
switching On the mower and resuming normal operation.
