1
OPERATION
The cord retainer prevents
the extension cord from being
disconnected during use.
1. Make a loop with the extension
cord (socket end of cord) through
the loop and secure over the
hook.
2. Once fitted, connect the lawn
mower power plug into the
extension cord socket
To obtain the desired cutting height, the front and rear axles are
repositioned on the underside of the mower housing.
1. Turn the mower upside down.
2. Pull the wheel axle towards the
front of the mower.
3. Locate the wheel axle into the
desired cutting height adjustment
position.
Note:
Make sure that both front
right and left wheel are located in
the same cutting height adjustment
position.
4. Pull the rear wheel axle towards
the mower’s catcher flap.
5. Locate the wheel axle into the
desire cutting height adjustment
position.
Note:
Make sure that both rear
right and left wheel are located in
the same cutting height adjustment
position.
WARNING!:
WHEN ASSEMBLING THE GRASS
CATCHER BACK TO THE MOWER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD
UP OF GRASS IN THE GRASS CHUTE. IF NEEDING TO
CLEAR THE GRASS, ALWAYS ENSURE THE MOWER
IS DISCONNECTED FROM THE POWER SUPPLY
PRIOR TO CLEARING. A BUILD UP OF GRASS IN THE
GRASS CHUTE MAY PREVENT GRASS FROM MOVING
INTO THE GRASS CATCHER EFFECTIVELY.
1. Secure the power cord running
from the switch housing to the
body of the mower by using the
two cord clips (supplied).
1. Assemble the grass catcher
handle onto the opening on the
top of the grass catcher. The
handle will click into position when
aligned and fitted correctly.
2. To assemble the grass catcher
align the two halves and push
them together, one side at a
time. Ensure the two halves click
together around the entire middle
section.
1. Lift up the catcher flap with one
hand and guide the catcher with
your other hand over the two
hooks on the mower housing
2. Lower the grass catcher and
allow it to sit in place. Lower the
catcher flap.
3. To empty the grass catcher, lift
the catcher flap with one hand
then lift the grass catcher with the
other hand up off the two raised
housing clips.
WARNING!
DISCONNECT THE MOWER FROM
THE POWER SUPPLY AND ENSURE THE BLADE
HAS STOPPED COASTING BEFORE ADJUSTING THE
HEIGHT.
Securing the Power Cord to the Handles
Assembling the Grass Catcher
Fitting and Removing Grass Catcher
Using the Cord Retainer
HOOK
2. PREPARATION
Cutting Height Adjustment
Cutting Height Positions
1
2
3
1. 30 mm (lowest)
2. 50 mm
3. 70 mm (highest)
The catcher must be attached to the two hooks on the mower.
“CLICK”
“CLICK”
“CLICK”
