Charging the Battery
The air pump has been shipped in a low charge condition. First read the safety
instructions and then follow the charging procedures.
1. Plug the AC charger adaptor (17) in an appropriate AC power outlet and switch on
at the mains.
2. Insert the charger jack (14) into the
charger cradle socket (15) (Fig.1).
3. With the 12V battery pack (5) sitting
flat on a bench/table, place the recess
of the charging cradle over the
battery terminal ensuring a firm connection (Fig.2). Upon proper contact, the red
light will illuminate.
NOTE:
The 12V battery pack (5) fits one way only. Ensure the “+” and “-” markings on
the recess side of the cradle are matched to those of the battery terminal.
The 12V battery pack (5) will take approximately 3-5 hours to charge. This may vary up
to 7 hours due to the level of charge left in the batteries and also the ambient
temperature.
Once the 12V battery pack (5) is fully charged, it is recommended that the charger is
disconnected from the power supply.
NOTE:
When the 12V battery pack (5) charge runs out after continuous use or
exposure to direct sunlight or heat, allow time for the 12V battery pack (5) to cool
down before recharging to achieve the full charge.
Removing / Installing 12V Battery Pack to the Air Pump Handle
Always switch off the air pump before insertion or removal of the 12V battery pack (5).
1. Locate the latches on the sides of the 12V battery pack (5)
and depress. Pull the 12V battery pack (5) from the handle of
the air pump (Fig.3).
2. After recharging, slide the 12V battery pack (5) into the
handle of the air pump; ensure the battery pack release
buttons (4) on either side of the 12V battery pack (5) click into
place and the 12V battery pack (5) is secured prior to using
the air pump.
Note:
Do not use force when inserting the 12V battery pack (5). If the 12V battery
pack (5) does not slide in easily; it is not being inserted correctly.
8
SET-UP AND PREPARATION (cont.)
Fig.1
Fig.2
Fig.3
Summary of Contents for APR-012
Page 1: ......
