ACP-2419
3. TROUBLE SHOOTING
Turning Off
1. After the task has been completed,
switch the compressor Off by
moving the On/Off switch to position
“O” (Off).
2 Switch off the mains power supply
and remove the electrical plug.
3. Release the remaining compressed air in the tank by use of an air
tool (blow gun etc).
Problem
Cause
Solution
The compressor
does not start
1. No power supply
1. Check the power
supply, the power
plug and the
socket-outlet.
2. Insufficient supply
power
2. Make sure that
the extension
cable is not too
long.
3. Outside temperature
is too low
3. Never operate
with an outside
temperature of
below 5°c.
4. Motor is overheated
4. Allow the motor
to cool down.
If necessary,
remedy the
cause of the
overheating.
The compressor
starts but there
is no pressure
1. Leak in the non-
return valve
1. Replace the non-
return valve
2. The seals are
damaged.
2. Check the seals
and have any
damaged seals
replaced by a
service centre
3. The drain plug leaks. 3. Tighten the
lever by hand.
Check the seal
and replace if
necessary.
The compressor
starts, pressure
is shown on the
pressure gauge,
but no pressure to
the air tool.
1. Loose hose
connections
1. Check the
compressed air
hose and tools
and replace if
necessary.
2. Leak in a quick-lock
coupling
2. Check the quick-
lock coupling
and replace if
necessary.
3. Insufficient pressure
set on the pressure
regulator.
3. Open the
pressure
regulator further.
WARNING!
TAKE CARE WHEN DISCHARGING AIR
THROUGH THE DRAIN PLUG OR THE AIR OUTLET.
THE DISCHARGE AIR CAN CAUSE DUST, STONES OR ANY
OTHER FOREIGN PARTICLES TO BE BLOWN THROUGH
THE AIR AT HIGH PRESSURE.
