![background image](http://html.mh-extra.com/html/ozito/abk-pro/abk-pro_instruction-manual_1666495005.webp)
• Keep the the airbrush clean at all times. If possible, prevent foreign matter from
entering the internals.
• If the body of the airbrush requires cleaning, never immerse any part of the
airbrush into a liquid.
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the airbrush by an unauthorised person or by mishandling
of the airbrush.
CLEANING PROCEDURE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLE SHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your local
council authority for recycling advice.
Spare parts can be ordered from the Special Orders desk
at your local Bunnings Warehouse.
for further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
Problem
Cause
Remedy
Little or no material
flow
Nozzle clogged
Fluid regulator too limited
Paint pot vent hole blocked
Paint too thick
Clean
Unscrew paint regulator
Clean
Thin material
Spray pattern is
heavy in the middle
Nozzle clogged
Not enough atomizing pressure
Clean
Unscrew the air regulator
Spray pattern is too
wide and misty
Too much atomizing pressure
Screw in the air regulator
or decrease air pressure at
the supply
Spray jet pulsates
Material in paint pot running out
Nozzle clogged
Material too thick
Refill
Clean or replace
Thin material
Pattern runs or sags
Applying to much material
Decrease fluid regulator or
increase movement speed
Too much overspray
Gun too far from spray object
Too much material applied
Reduce distance
Decrease fluid regulator
Pattern is very light
and splotchy
Moving the airbrush to fast
Decrease fluid regulator or
decrease movement speed
NOTE:
After each use it is essential that the airbrush is cleaned
thoroughly. Failure to do so will likely cause blockages which
will prevent the tool from working.
FAILURE TO CLEAN THE TOOL WILL VOID THE WARRANTY.
1 Empty the paint pot of
remaining material.
2 Fill paint pot with appropriate
cleaning solution.
3 Connect the airbrush to
the air supply then spray
solution onto a scrap piece of
carboard.
4 Repeat steps 2-3 until the
cleaning solution runs clear
from gun.
5 Disconnect the airsupply. Remove the paint pot and rinse.
Warning
Read instruction
manual
Wear eye protection
and breathing mask
Cubic feet per minute
Wear ear protection
Millilitres per minute
ml/min
cfm
MAINTENANCE