10 • Oz Charge manual
www.ozcharge.com.au
TROUBLE SHOOTING
Problem
Indication
Possible Causes Suggested Solution
Charger does not
work?
No Indicator
lights on
- No AC power
- Check AC connections and
make sure the AC Power Point is
switched ON.
- Try a different AC Power Point
which you know is working.
Charger has no DC
output?
Red Fault LED
is ON
or
Battery type
LED is flashing
- Reverse polarity
protection
- Loose / bad
connection to the
battery
- No battery
connected or
detected.
- Battery voltage
is below 2V so
the charger is
not recognising
a battery is
connected and
is going into Eco
mode.
- Check DC connection between
charger and battery and make
sure they are not short circuited.
(Touching each other)
- Check that the crocodile clips
have not fallen off or come loose.
- Check that the crocodile clips/
ring terminals are connected to
the correct polarity.
Note:
The charger output is only
present when connected to a
battery.
The full light won’t
come on.
Red Fault
LED is ON or
Flashing
- Battery Ah
capacity too large
for the battery
charger and it has
timed out
- Battery is
defective
- Battery is severely
sulphated
- Check the charger
specifications match the battery
capacity. Eg. make sure battery
capacity is not too big for the
charger. If trying to maintain a
dead flat larger capacity battery,
switch the AC power off then
back on to reset and resume
charging.
- Battery needs to be checked
out or replaced.
Green Full LED
flashing.
Green Full LED
flashing.
- Final analysis
check failed.
- Battery is sulphated or lost
capacity and is not holding
charge. Battery needs to be
checked out or replaced.
REPLACEMENT PARTS
For the full range of replacement parts and accessories, please visit our website:
www.ozcharge.com.au. / www.ozcharge.co.nz
