-
3-
CONTROL AND INDICATORS
1.
Charge stage indicator LED’s.
Shows what the stage of charge mode is. See page 7 for details.
The
Float/PS
LED will automatically come on when used with no battery as a Power Supply (PS).
2.
Battery Type button.
Allows the user to program the charger for the battery type connected. Hold for 3 seconds to change.
See page 5 for details on each battery type.
3. Battery Type selection.
Shows what battery type is programmed. Use
Battery Type
button to change.
4. Equalisation button.
Allows the user to start an Equalisation charge cycle. Hold for 3 seconds to begin.
Refer to page 7 before use!
5.
Fault, Rejuvenation and Equalisation mode LED’s
Refer to page 7 & 8 for more information.
INSTALLATION
This product is designed to be installed in a hardwired situation only.
Because this charger has no fan it is important to
mount it an area of good ventiallation.
Nothing should
located be within 100mm (4 inches) of the charger unit to ensure natural convection cooling takes place.
Choose a suitable location that meets these requirements. In camper-trailers and caravans especially make
sure the location is not used for storage of things that may limit the airflow like tents/swags/canvas awnings
that may wrap around the unit during travel and not be unfolded or used at the next destination.
NOTE if this charger does get too hot, it is not a danger as the unit will
automatically “foldback” and
reduce the output the current and continue to work at a lower power level to prevent overheating. The
battery recharge time however will be longer. Only in extreme ambient heat environments the unit may
shutdown.
