7
With the convex centre part of
the wheel towards the inside, insert
a wheel axle (38) through each
wheel (9) and wheel leg (6/7).
Put an axle washer (36) on the other
side, then insert the axle pin (35)
through the hole in the wheel and
wheel axle.
Turn over the assembled legs/bottom
shelf, then use the provided open
end wrench to mount a caster (8)
on each caster leg (4/5) by clockwise
turning the hex nut on the caster into
the threaded hole at the bottom of
the leg tube.
caster leg
caster
wheel leg
axle
pin
axle
washer
wheel axle
wheel
Set the assembled legs/bottom shelf upright, then hold and slightly press the legs
downwards to ensure all the wheels and casters land on floor. Tighten all the screws
.
mounT THe LegS on THe griLL
Parts required:
Grill (1)
Hardware required:
4 x Bolts 1/4" (39)
4 x Nuts 1/4" (34)
4 x Flat washers 1/4" (33)
4 x Spring washers 1/4" (37)
Tools required:
Open end wrench (40)
Take the porcelain grill (16) and grease
drain pan (17) out of the grill (1), if you
haven’t already done so.
paddle
vent
washers
nut
grill
bolt
Place the grill on the legs. NOTe: The two wheel legs should be at the same side as the
paddle vent (15).
After aligning the holes in the grill and the legs, insert a 1/4" bolt (39) through each leg
tube, then through the grill.
Put a 1/4" flat washer (33) and a 1/4" spring washer (37) on each bolt inside the grill,
then put on a 1/4" nut (34) and tighten it.
