11
7.
Installing the brake levers
Existing brake levers should be replaced by the brake levers supplied
in the kit. The sensor from the lever should be plugged in directly into
display’s 2-pin connector.
8.
Connecting the connectors.
When connecting the connectors the extra caution shall be taken. Each
connector has an arrow moulded on the surface. When joining
connectors it is crucial that the arrows always are pointing out on each
other. In this set the right pins meet their joining sockets.
Please note that neglecting this step may cause the shortcuts in
the entire system which will cause the permanent damage to
the controller and the harness.
