OXO [T]Box RDM, User Instruction

Page: 10 / 30

The default total channels is set to be 000 and the start channel always is automatically preset
to be 001. If you would like to change the start channel, turn the Dial wheel to select > at
the right side of the LCD window. You can scroll to the desired channel No., then press the
Dial wheel again to confirm.
On the contrary, if there is signal input, the LCD window will display the values of received
signals in the following diagram. For example( e.g. Sirocco ).
< RX Channel :192 ?
001:
011:
021:
< 1. Barchart display
x = no signal
- = no data
< RX Channel : 000 ?
Start Channel : 001 >
--- --- --- --- ---
> --- --- --- --- ---
Each line can indicate the values of 10 channels in all. To browse the other values of channels,
turn the Dial wheel forward to select
, then press the Dial wheel . At this time you can
turn Dial wheel backward or forward for this purpose.
>
On the contrary, if there is signal input, the LCD window will display the values of received
signals in the bar chart diagram.( e.g. Sirocco )
Each bar chart indicates the
different value of the fader.
For the further information, you may use the help function by pressing Dial wheel. The help
information shows as below.
This option can display the value of signal input by the means of decimal, hexadecimal and
percent. Turn the Dial wheel forward to enter the Barchart display option. If there is no
signal input, the LCD window always show empty information as follows:
2. Value display
< RX Channel 192 ?
Start Channel : 001 >
255 255 255 000 000
> 000 000 000 000 000
User's Instruction
Page 10
[T]Box-RDM