3.Functions and Operations
25
for the measurement based on the input.
Note:
Frequency range: XDM3051 is 20 Hz to 1 MHz; XDM3041 is 20 Hz to 500 kHz.
Period range: XDM3051 is 0.05
s to 1 μs
; XDM3041 is 0.05 s to 2
μs
.
750 V input protection is available in all ranges.
4.
Set the relative value.
(Advanced operation)
Press the Rel softkey to turn on or off the relative operation. For relative operation,
the multimeter subtracts the pre-specified value of REL operation from the actual
measurement result and displays the result. See page 31,
Relative Value
.
Measuring Temperature
This section describes how to configure temperature measurements.
Temperature
measurements require a temperature transducer probe. The supported probes are type B,
E, J, K, N, R, S, T thermocouples, and PT100, PT385 platinum RTD sensor.
Operating Steps:
1.
Enable the temperature measurement.
Press
on the front panel to enter temperature measurement mode.
2.
Connect the test lead.
Temp Transducer
I
3.
Set the sensor configuration file.
Press the Load softkey, press
to select thermocouple or thermo resistor. Press
to access the list, press
to select the desired configuration file. Press the
