13
GB
Starting the outdoor sensor /
changing batteries
Open the battery compartment
21
on the back of the outdoor
sensor by sliding the battery cover
18
in the direction of the arrow.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
21
.
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The signal LED
17
at the front of the outdoor sensor will briefly
light up. The signal LED will then flash about twice a minute,
indicating wireless transmission.
Starting the main station / changing batteries
Open the battery cover
5
at the back of the main station by
pulling up on the tab at the bottom of the battery compartment.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
16
.
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The display
1
will briefly light up and run a brief check of all
display elements.
Plug the low voltage plug of the mains adapter
30
into the mains
adapter socket
31
in the main station and plug the mains adapter
into an easily accessible outlet. The display will permanently light
up and run a brief check of all display elements.
Note:
Batteries power supply only for data backup only. When
you unplug the mains adaptor
30
, the storage setting value will
not be delete.